Omnitron Systems Technology iConverter GX/TM Manual de usuario descargar pdf (Pagina 31)

4.3.1 Port Access

The Port Access option allows the ports to be disabled/enabled while maintaining the port configuration

and network link

To configure Port Access, select option 1 for the Fiber port and option 2 for the UTP port from the Port

configuration screen.

4.3.2 SFP Information

The GX/TM module installed with an SFP will provide general and specific information on the SFP. This

information is best viewed with SNMP management software. The following is the information available:

4.3.2.1 SFP A0 Information Display

This section displays fixed SFP Module information for the following areas.

• Identifier Values • Extended Identifier

• Connector Values • Transceiver Codes

• Encoding Rules • Normal Bit Rate

• Link Length • Vendor Name

• Vendor OUI • Vendor Revision Number

• Laser Wavelength • Options

• Vendor Serial Number • Date Code

• Diagnostic Monitoring Type • Enhanced Options

• SFF-8472 Compliance

4.3.2.2 SFP A2 Information Display

This section displays decoded SFP data collected for the following statistics.

• Measured Temperature • Measured Vcc

• Measured Bias • Measured Tx Power

• Measured Rx Power • Temperature High Alarm Setting

• Temperature Low Alarm Setting • Temperature High Warning Setting

• Temperature Low Warning Setting • Vcc High Alarm Setting

• Vcc Low Alarm Setting • Vcc High Warning Setting

• Vcc Low Warning Setting • Bias High Alarm Setting

• Bias Low Alarm Setting • Bias High Warning Setting

• Bias Low Warning Setting • Tx Power High Alarm Setting

• Tx Power Low Alarm Setting • Tx Power High Warning Setting

• Tx Power Low Warning Setting • Rx Power High Alarm Setting

• Rx Power Low Alarm Setting • Rx Power High Warning Setting

• Rx Power Low Warning Setting

SFP information can be obtained by selecting option 9 from the Port configuration screen.

Page 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Sin comentarios

Omnitron Systems Technology iConverter GX/TM Manual de usuario Pagina 31