Omnitron Systems Technology iConverter GX/TM Manual de usuario descargar pdf (Pagina 12)

3.4 CONFIGURE THE MODULE VIA COMMAND LINE INTERFACE

PI SA

To configure, attach the GX/TM to a DB-9 serial (RS-232) equipped computer with terminal emulation

software such as HyperTerminal. The GX/TM Serial Console Port (DCE) is a mini DIN-6 female connector

which can be changed to a DB-9 connector with the included adapter (Part #8082-0). Attach the ends of a

serial cable to the serial port of the PC and the Serial Console Port of the GX/TM. This is a standard

asynchronous serial interface. The pin-outs are illustrated below.

Serial Connector Pin Outs

Start HyperTerminal and select the correct COM Port in the HyperTerminal “Connect To:” window.

Set the PC’s serial port to the following:

Bits Per Second: 57,600

Stop Bits: 1

Data Bits: 8

Parity: NONE

Hardware Flow Control: NONE

Power the chassis containing the GX/TM module and press <ENTER> to bring up a command line prompt

on the attached PC.

The module is configured with the following defaults:

IP Address: 192.168.1.220

IP Subnet Mask: 255.255.255.0

Passwords

Serial: No password assigned

FTP: No password assigned

Telnet: public

SNMPv1/v2c Communities

READ: public

WRITE: public

SNMPv3 Parameters

User 1 name (read only): guest

User 2 name (read/write): admin

User 1 Privacy pwd: publicguest User 1 Authen pwd: publicguest

User 2 Privacy pwd: privateadmin User 2 Authen pwd: privateadmin

Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Sin comentarios

Omnitron Systems Technology iConverter GX/TM Manual de usuario Pagina 12